MacDon R116 Installation Instructions Manual page 3

Introduction
The Small Drum kit (MD #259140) can be installed on a MacDon R116 Rotary Disc Pull-Type (model years 2015–2017) to
improve cutting performance in certain conditions. The kit contains two drums and associated parts to replace the factory-
installed inner drums on the pull-type.
This document explains how to install the kit. A list of parts included in the kit is provided in Chapter 2 Parts List, page 5.
Installation time
Installation time for this kit is approximately 2.5 hours.
Conventions
The following conventions are used in this document:
• Right and left are determined from the operator's position. The front of the pull-type is the side that faces the crop.
• Unless otherwise noted, use the standard torque values provided in the pull-type operator's manual and technical
manual.
NOTE:
Keep your MacDon publications up-to-date. The most current version of this instruction can be downloaded from our
Dealer-only site (https://portal.macdon.com) (login required).
NOTE:
This document is currently available in English only.
i
214913 Revision B