Download  Print this page

Optional Accessories; Carrying Tool; Maintenance - Makita DLW140 Instruction Manual

Cordless portable cut-off
Hide thumbs


Table of Contents
When the cut-off wheel has worn down considerably,
place a spacer block behind the workpiece as shown
in the figure. You can more efficiently utilize the worn
wheel by using the mid point on the periphery of the
wheel to cut the workpiece. Use a sturdy and non-flam-
mable material for a spacer block.
► Fig.18: 1. Spacer block
When cutting workpieces over 85 mm wide at an angle,
attach a straight piece of wood (spacer) over 190 mm
long x 40 mm wide to the guide plate as shown in the
figure. Attach this spacer with screws through the holes
in the guide plate. Make sure that the cut-off wheel does
not contact the spacer when the tool head is depressed.
► Fig.19: 1. Guide plate 2. Spacer block (over 190
mm long x40 mm wide) 3. Workpiece (over
85 mm wide) 4. Vise plate
When using a spacer block, install the
guide plate to the position nearest to the neck of
the tool head.
► Fig.20
When the cut-off wheel has worn down, raise the cutting
position by putting a spacer block which is slightly nar-
rower than the workpiece as shown in the figure. This
will help you to utilize the cut-off wheel economically.
► Fig.21: 1. Vise plate 2. Workpiece diameter
3. Guide plate 4. Spacer block width
Long workpieces must be supported by blocks on
either side so that it will be level with the base top. Use
non-flammable material for supporting blocks.
► Fig.22: 1. Supporting block

Carrying tool

Before carrying, remove the batteries and fold down
the tool head, and then lock it. Hold the handle when
► Fig.23


Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Abrasive cut-off wheels
Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.


Table of Contents

  Also See for Makita DLW140

  Related Manuals for Makita DLW140