Fixation Of The Hydraulic Power Unit - Bosch Rexroth CytroPac Operating Instructions Manual

Dimension "X" - Pressure connection "P"
65
64
61
58
57

7.2.2 Fixation of the hydraulic power unit

For fixation of the hydraulic power unit, an optional installation plate (mounting kit
including installation plate and M6 x 430 screw, see chapter 17.3 "Accessories") is
available.
▶ Bend the clip by 90° as illustrated in fig. 7 and fig. 10.
▶ Place the installation plate in correct position on a level surface.
This defines the arrangement of the hydraulic power unit.
▶ Attach the installation plate with four mounting screws, e.g. M8 x 20 (not
included in the scope of delivery) at the contact area.
▶ Position the hydraulic power unit on the installation plate. Thanks to the
embossed locking mechanisms, the hydraulic power unit slides on the installation
plate.
If the hydraulic power unit is not positioned completely on the installation plate
like illustrated in fig. 9 and fig. 10 but on the locking mechanisms, the hydraulic
power unit can be slightly rotated into the correct position.
▶ Attach the hydraulic power unit with the screw M6 x 430 and the toothed washer,
see fig. 8 and fig. 9, to the installation plate. Tighten the hexagon socket head cap
screw with a maximum of 2 Nm and a thread locker.
Fig. 7: Installation plate (optional)
NG of the installed pump
AS04
AS05
AS08
AS11
AS14
4 x ø9
CytroPac, RE 51055-B/06.17, Bosch Rexroth AG
Assembly 31/84
3
4
5
6