Checking The Heat Exchanger - Bosch Rexroth CytroPac Operating Instructions Manual

62/84 Maintenance and repair
Leakage
Cracking and resulting
leakage
External force effects
Corrosion
Bosch Rexroth AG, CytroPac, RE 51055-B/06.17
In case of leakage at screwed-in components, these must be tightened and
documented. If leakage still occurs at this position, the contact must be thoroughly
checked for the cause of leakage. Depending on the result, seals and/or the
component must be replaced.
In case of cracking and resulting leakage, the cause must be identified and
corrected. Afterwards, affected components must be replaced or thoroughly
repaired.
In case of indications of external force effects, the cause must be identified and
corrected. Afterwards, the component and enclosing components must be checked
for damage and assessed for further reliable use.
As required, these components are to be replaced or thoroughly repaired.
In case of indications of corrosion, the component must be checked for damage and
assessed for further reliable use. As required, this component is to be replaced or
thoroughly repaired. In any case, corrosion protection must be ensured.

10.5.9 Checking the heat exchanger

The heat exchanger does not require specific maintenance. The set-up of the heat
exchanger is robust and does not lead to any increased requirements for the cooling
water unit. Dirt particle must not exceed 1 mm.