Multi-Ethernet Interface Settings, Profinet Operating Mode - Bosch Rexroth CytroPac Operating Instructions Manual

8.3.2 Multi-Ethernet interface settings, PROFINET operating mode

• The multi-Ethernet interface is only available in "Premium" configuration.
Bosch Rexroth recommends parameterization of the communication settings in
the frequency converter of the power unit before establishing communication
with the control system.
The following general parameter settings are pre-set for PROFINET communication:
• Parameter E0.01 = 2
• Parameter E0.03 = 2
• Parameter E8.00 = 1
• Parameter F1.03 = 3
• Parameter F1.11 = 2
• Parameter H3.40 = PN
Table 7: Process data output (status words)
Process Status word
H3.30 [0] = H0.01 Bit 0: Backwards (low = forwards)
Bit 1: Start
Bit 2: Jog mode
Bit 3: Acceleration
Bit 4: Deceleration
Bit 5: Overvoltage limitation
Bit 6: Over-current limitation
Bit 7: Error
Bit 8 to 15: Error code
H3.30 [1] = d0.01 Actual speed value in rpm (without decimal digits)
H3.30 [2] = d0.82 Actual pressure value in bar (one decimal digit)
H3.30 [3] = d0.88 Process warnings
Bit 0: No active warning
Bit 1: Actual pressure limit value exceeded
Bit 2: Pressure command limit value exceeded
Bit 3: Flow command limit value exceeded
Bit 4: Warning! Oil filter contaminated
Bit 5: Warning! Oil filling level too low
Bit 6: Warning! Oil temperature too high
Bit 7: Warning! Oil exchange required
Bit 8: Backup
Bit 9: Warning! Pump-temperature protection
Bit 10: Warning! Pump performance limit reached
H3.30 [4] = d0.89 Process faults
Bit 0: no active fault
Bit 2: Error! Pressure sensor
Bit 3: Error! Parameter value error
Bit 4: Error! Oil filter contaminated
Bit 5: Error! Oil filling level too low
Bit 6: Error! Oil temperature too high
Bit 7: Error! Oil exchange required
Bit 8: Error! Oil filling level too low or oil temperature too high
Bit 9: Error! Pump temperature protection
Commissioning
CytroPac, RE 51055-B/06.17, Bosch Rexroth AG
53/84