Navigating To A Specific Point - Raymarine E Series Reference Manual

81244_4.book Page 70 Thursday, January 31, 2008 1:53 PM
70

4.9 Navigating to a specific point

You can use your chart to navigate to a specific point marked by the cursor (temporary
waypoint) or to a waypoint. If required you can display the largest chart scale possible
that will display both your boat and the target waypoint. When you navigate to a
waypoint or to the cursor position, the data is sent on NMEA 0183 and SeaTalk and can
be used by an autopilot, if connected. On arrival at the specified point a message is
displayed and an alarm sounds.
When you are steering manually, you can also use the chart to determine the bearing
or direction to steer.
Note:
must press
4nm
Boat's heading changes
to follow course to
temporary waypoint
To go to the cursor position:
Position cursor at
desired destination
Note:
If you are currently navigating a route or going to the cursor /waypoint, you
before the system can commence a new GOTO request.
STOP GOTO,
North-Up (Relative Motion)
STOP GOTO
Press to stop GOTO
and remove
temporary waypoint
GOTO...
This target waypoint is also identified on the radar
E-Series Networked Display Reference Manual
RESTART XTE
Dashed line Temporary waypoint
marking original (within white box)
course of GOTO placed at cursor
GOTO CURSOR
Temporary waypoint
placed at the cursor.
Local
GOTO CURSOR
Temporary
waypoint
name