Displaying Vessel Identity (Ais); Setting Up Your Radar - Raymarine E Series Reference Manual

81244_4.book Page 179 Thursday, January 31, 2008 1:53 PM
Chapter 7: Using the Radar (Analog)
To cancel an individual target:
To cancel all targets:

Displaying vessel identity (AIS)

If you have an AIS receiver fitted to your system, you can use the AIS feature to:
• Display a target for any other AIS equipped vessels within a specified range of your
boat.
• Display voyage information being broadcasted by these targets i.e. their position,
course, speed and rate of turn.
• Display basic or detailed information for each target vessel including safety critical
target data.
• Set up a safe zone around your boat.
• View alarm and safety related messages.
This information is displayed in the form of an overlay or as a dialog box on your radar
screen. To overlay AIS on a radar window:
For more information on AIS, refer to
(AIS)
.

7.11 Setting up your radar

The set up for your radar can be changed from the standard configuration to suit your
particular needs. Although you will probably only do this when you first use the radar,
you may decide to make subsequent adjustments once you become more familiar with
the system. Any settings that you change are retained and become the default settings
even when you power off.
To select the Scanner Setup menu from the Radar Setup menus when a radar window
is active:
MARPA LIST...
ID Bearing Range Course Speed CPA TCPA
0 0
1 137 T 1.4nm 180 T 2.2kt 1.4nm 2min
0 0
2 187 T 4.0nm 130 T 1.5kt 4.0nm 8min
Highlight target to be cancelled
CANCEL ALL
OK
TARGETS
PRESENTATION
Chapter 17:Automatic Identification System
CANCEL TARGET OK
AIS LAYER
ON
179