Setting The Motion Mode - Raymarine E Series Reference Manual

81244_4.book Page 194 Thursday, January 31, 2008 1:53 PM
194
Course-Up (C-UP)
If you select a new course, the picture will reset to display the new course upwards.
The reference used for Course-Up depends upon the information available at a given
time. The system prioritizes this information in the following order:
1. Bearing from origin to destination (your intended course).
2. Locked heading from an Autopilot.
3. Bearing to waypoint.
4. Instantaneous heading.
If heading data becomes unavailable while in this mode a warning message is
displayed; the status bar puts Course-Up in brackets to show it is suspended; and
the radar uses 0° heading in relative motion mode.
When heading data becomes available again, Course-Up mode is reinstated.
To select an orientation mode
1. Press the PRESENTATION softkey.
2. Press RADAR MODE & ORIENTATION.
3. Choose your preferred setting under the ORIENTATION softkey.
The selected orientation mode is displayed in the status bar.

Setting the motion mode

Motion modes control how your progress is represented on the display. The selected
motion mode is displayed in the status bar. If no position data is available, the status
bar shows the motion mode in brackets.
There are two motion modes:
• Relative motion
• True motion
The default setting is relative motion.
e.g:
N
Current course upwards
E-Series Networked Display Reference Manual
N
As your boat's heading changes:
Radar picture fixed
SHM rotates accordingly