To Engage The Autopilot From The Setup Menu; To Disengage The Autopilot In Normal Operation; Emergency Disengage - Raymarine E Series Reference Manual

81244_4.book Page 220 Thursday, January 31, 2008 1:53 PM
220
When the autopilot is engaged, or you hotspot an active route or waypoint, the toolbar
gives you the following options:
Table 10-1:
STOP GOTO/FOLLOW
ADVANCE WAYPOINT
Note: You can only perform individual advance waypoint operations: it is not possible to per-
form one track command for multiple advance waypoints.

To engage the autopilot from the Setup Menu

At any time, you can open the Pilot Control screen from the Setup menu:
1. Press MENU.
2. On the Setup Menu, select Autopilot Control.
3. Press the ENGAGE PILOT -TRACK- softkey.
Press OK or CANCEL to go back to the previous screen.

To disengage the autopilot in normal operation

You can disengage the autopilot from the Pilot Control screen.
1. Press the STANDBY softkey.

Emergency disengage

Alternatively, if the Pilot Control screen is not displayed, you can disable the autopilot
using the power key.
1. Press and release the power button.
2. Press the STANDBY softkey.
This puts the autopilot into standby mode.
E-Series Networked Display Reference Manual
Active Navigation Toolbar
Opens the Pilot Control screen. If the autopilot is in
track mode, the route complete alarm sounds.
Opens the Pilot Control screen and provides the
AUTO and TRACK softkeys. The screen stays open
until you choose either AUTO or TRACK.