Table of Contents
Advertisement
Section 4 – Installing Supporting Furniture and Casework
4.15 Attaching a Pullboard to a
Table
Tools Required:
7/16" Wrench
Phillips head screwdriver with No. 2 and 3 tips
Hardware Included:
Hardware Bag No. 830629 consisting of:
2
Top brackets
2
1/4-20 Hex nuts
2
1/4-20 x 5/8" PPHMS
Refer to Figure 4-35
1. Slide the pullboard out of the frame assembly as
far as it will go.
2. Insert a screwdriver into the 7/8" hole and push
the tab up to release while removing the
pullboard.
Refer to Figure 4-36
3. Assemble the top brackets and 1/4-20 x 5/8"
machine screws to the pullboard frame.
Do not tighten the brackets at this time.
Refer to Figure 4-37
4. Insert the back clips of the pullboard frame into
the back channel of the work surface frame.
5. Attach the pullboard to the front "C" channel and
tighten the top brackets to the "C" channel.
6. Insert the pullboard into the frame assembly.
Figure 4-36 Attaching Pullboard
Pullboard Frame Assembly
Top Brackets
1/4-20 x 5/8" PPHMS
MAX/Wall
Technical Wall System
®
Figure 4-35 Attaching Pullboard
Front Channel
Figure 4-37 Attaching Pullboard
Pullboard
Back Channel
1/4-20 Nut
57
Advertisement
Table of Contents
