Table of Contents
Advertisement
MAX/Wall
Technical Wall System
®
Section 4 – Installing Supporting Furniture and Casework
4.10 Floor and Wall-Mounted
Cabinets
Note: The following bag assemblies may be shipped in
one package, or in separate packages with each
product.
Hardware Included:
Floor-mounted cabinet, Bag No. 681363:
4 1/4-20 x 1/2" PPHSMS
4 Lockwashers
4 1/4-20 hex nuts
4 No. 10 x 3/4" PPHSMS
4 Shelf supports
Upper cabinet with two shelves, Bag No. 681365:
(Same as above except 8 Shelf supports)
Upper cabinet with three shelves, Bag No. 681366:
(Same as above except 12 Shelf supports)
Full-height cabinet with five shelves, Bag No. 681367:
(Same as above except 20 Shelf supports)
Shelf support, Bag No. 6811771:
4 Shelf supports
1/4-20 x 1/2"
PPHMS (4)
12 x 3/4"
PPHSMS
Secure with 1/4-20 x 1/2" PPHMS,
1/4-20 Hex Nut, and Washer -
8 Required per Angle
Figure 4-19 Floor and Wall-Mounted Cabinets
48
1/4-20 Hex Nut (4)
Washer (4)
Wall & Upper Cases
1/4-20 Hex Nut (4)
Hardware shown enlarged
for easy identification
Refer to Figure 4-19.
Most installers prefer to hang wall cases first, which
eliminates working over the base assemblies. Each
wall case is hung from steel cleats and a horizontal
wood filler block. The steel cleats are screwed to the
studs in the wall. Screws also extend through the
back of the wall case, through the wood filler block
and into the wall studs. If specifications indicate a
different type of hanger, contact the Project Manager.
When a row of wall cases is indicated, snap a chalk
line so all the cleats will be at the same level.
Toggle bolts, Rawl plugs, Red Devil plastic anchors,
tap-in nylon fasteners and bolts are the various type
fasteners used to anchor the wood cleats to the wall
– wall construction is the determining factor.
Fasteners are furnished by the installer.
Tall and floor-mounted cabinets should be checked to
make sure they are not racked out of square by
uneven floors. This is important to insure smooth
operations of the drawers and doors.
Tall and floor-mounted cabinets should be anchored
to the wall and bolted together.
Wall
Cabinet
1/4" Locate
Screws
Wall Case Cleat
Washer (4)
1/4-20 x 1/2" PPHMS (4)
Base Scribe Angle,
Only on Exposed Ends
Wood Wall Cleat, 1-Required
per Counter & Tall Case
12 x 3/4"
PPHSMS
Advertisement
Table of Contents
