Table of Contents
Advertisement
MAX/Wall
Technical Wall System
®
Section 4 – Installing Supporting Furniture and Casework
4.2
Cantilever Table to Wall
Frame
(cont.)
Refer to Figure 4.3
6. When the cantilever tables are installed next to
each other and at the same height, they must be
bolted together. Insert a 5/16-18 x 3-1/2" bolt
through the holes at the front of the cantilever
frames and secure with a 5/16-18 nut.
Note: Washers are provided to shim between the
cantilevered legs if necessary.
Refer to Figure 4.4
7. Attach the work surface to the
table frame using top brackets and
No. 10 x 1" screws. Top brackets
are hooked onto "C" channels at
the front of the table frame.
Location and number of clamps
to be used is dependent upon
the number of holes pre-drilled into
the work surface.
Table Top
10 x 1"
Screw
C-Channel
Cantilever Frame
36
Cantilever
Frame
5/16-18 x 3-1/2" Bolt
Table Top
Cantilever Frame
Top
Bracket
Figure 4-4 Attaching Work Surface to Cantilever Frame
5/16-18 Nut
Figure 4-3 Bolting Cantilever Frames Together
Wall Frame
Wall Frame Assemblies
Advertisement
Table of Contents
