Ceiling Facing Inserts, Steel; Ceiling Facing Inserts, Fabric - Thermo Scientific FISHER HAMILTON MAX/WALL Installation Manual

MAX/Wall Technical Wall System
®
Section 3 – Installing Wall Frames
3.12 Ceiling Facing Inserts
Tools Required:
Phillips screwdriver
Jigsaw with metal cutting blade
Hardware Included:
4 /8 x 1/2" PPHSMS
4 Retainer clips
Procedure:
1. Cut the top edge of the panel to the required
height as necessary.
2. To apply the reinforcing angle to the back side,
at the top of the panel; clean the location with
mineral spirits and allow to dry before applica-
tion. Peel release film from foam tape and attach
to the panel.
3. Fasten the retainer clips to the top surface of the
top rail of the wall frame.
4. Insert the top of the panel into the opening of the
ceiling channel and slide the lower panel flange
in under the retainer clips. See Figure 3-21.
Figure 3-21 Ceiling Facing Inserts, Fabric
30
Ceiling
Extensions
Ceiling
Facing
Insert
No. 10 x 5/8"
PPHSMS
Top Frame Rail
3.13 Ceiling Facing Inserts,
Steel and Fabric
Tools Required:
Phillips screwdriver
Jigsaw with metal cutting blade
Hardware Included:
4 /8 x 1/2" PPHSMS
4 Retainer clips
Procedure:
1. Cut the top edge of the panel to the required
height as necessary.
2. Fasten the retainer clips to the top surface of the
top rail of the wall frame.
3. Insert the top of the panel into the opening of the
ceiling channel and slide the lower panel flange
in under the retainer clips. See Figure 3-21.
Ceiling Channel
Top Frame Rail
Retainer Clips
Ceiling
Facing
Insert
Reinforcing
Angle
Foam Tape
Reinforcing Angle