Thermo Scientific FISHER HAMILTON MAX/WALL Installation Manual page 54

MAX/Wall Technical Wall System
®
Section 4 – Installing Supporting Furniture and Casework
4.12 Installing Suspended
Cabinets
Refer to Figure 4-29
4. Use the upper front brackets as shown to attach
the front of the cabinet to the front "C" channel
of the work surface frame. Tighten the 1/4-20 x
2" carriage bolts.
5. Tighten the carriage bolts in the upper rear
brackets until the suspended cabinet hangs
square to the frame.
Refer to Figure 4-30
6. Use the bottom clip and the 1/4-20 x 1" machine
screw to join the two cabinets suspended
side-by-side. Use one clip on the front and one
on the rear of the cabinet bottom side flanges.
7. Insert the drawers into the suspended cabinet.
9/16"
Attaching front top clamp to frame and
54
(cont.)
Upper Front
Frame Member
Suspended Cabinet
Accent (J-Line) cabinet
Figure 4-29 Attaching Front Top Clamp
Cabinet No. 1
Cabinet Bottom
Side Flanges
Figure 4-30 Securing Side-by-Side Cabinets
Attach a third top front
clamp at center location
for 36–48" wide cabinets
2"
Clamp
3/16"
Attaching front top clamp to frame and steel cabinet
Cabinet No. 2
1/2-20 x 1"
Machine Screw
Bottom Clip
Suspended Cabinet
Upper Front
Frame Member
Suspended Cabinet
Clamp