Table of Contents
Advertisement
MAX/Wall
Technical Wall System
®
Section 3 – Installing Wall Frames
3.9
Corner Filler – Three- and
Four-Way Connector/Fillers
Tools Required:
9/16" Wrench
Hardware Included – Three-Way:
12
HHCS, 3/8-16 x 2-1/2" Grade 5
12
Hex Nut, 3/8-16
24
Washers
Hardware Included – Four-Way:
16
HHCS, 3/8-16 x 2-1/2" Grade 5
16
Washers
26
Procedure:
Refer to Figure 3-16:
1. Loosely assemble the brackets to one of the wall
2. Position the remaining two or three wall frames
3. Align all of the wall frames checking that they are
3/8" Washer
3/8"-16 Bolt
End Panel
Figure 3-16 Corner Filler – Four-Way
4. For an 84" high end filler panel, insert the upper
frame uprights using the appropriate length of
3/8" bolts.
against the brackets on the first wall frame and
loosely assemble them to the brackets using the
appropriate length of 3/8" bolts.
square and level, and tighten all the 3/8" bolts.
3/8"-16 Nut
3/8" Washer
tab on the end filler panel over the flange on the
upper bracket – filler panel must be tilted out
slightly at its base to do this. Push the filler panel
in firmly against panel uprights and slide down to
engage lower tab on the end filler over the flange
on the lower bracket.
3-Way Corner
Bracket
Island Panel
Uprights
Advertisement
Table of Contents
