Reference/Pencil Drawer - Thermo Scientific FISHER HAMILTON MAX/WALL Installation Manual

MAX/Wall Technical Wall System
®
Section 4 – Installing Supporting Furniture and Casework
4.14 Attaching a Reference Drawer
or Pencil Drawer to a Table
Tools Required:
7/16" Wrench
Hardware Included:
Hardware Bag No. 830544 consisting of:
2 Top brackets
2 1/4-20 Hex nuts
Refer to Figure 4-33
1. Remove the reference/pencil drawer from the
frame assembly.
2. Attach the two clamps to the frame assembly using
the 1/4-20 nuts provided. Do not tighten the clamps
at this time.
Refer to Figure 4-34
3. Determine where the reference/pencil drawer is
to be located under the work surface.
4. Insert the back end of the frame into the back channel
of the work surface frame.
5. Use the clamps to attach the front end of the frame
assembly to the front "C" channel.
6. Adjust the frame perpendicular to the "C" channel and
tighten the 1/4-20 nuts on the clamps.
7. Insert the reference/pencil drawer into the frame
assembly.
Note - Clips MUST
be fully engaged
Reference/Pencil Drawer Frame
56
C-Channel
Rear Clip
Figure 4-34 Attaching Reference/Pencil Drawer
1/4-20 Nut
Top Bracket
Note - These clips are used
for Corner Lab Units Only
Figure 4-33 Attaching Reference/Pencil Drawer
C-Channel
Work Surface
Frame
Reference/Pencil Drawer Frame
Reference/Pencil
Drawer Frame
Front Top Bracket
1/4-20 Nut