Table of Contents
Advertisement
Section 3 – Installing Wall Frames
3.14 Lower Facing Inserts, Steel
Tools Required:
Mineral spirits
ScotchBrite pad
Lower Panel
Figure 3-22 Lower Facing Inserts, Steel
Procedure:
1. Hold facing insert into position and note location
of the dual-lock strips that are attached to the
insert.
2. Apply mineral spirits to the ScotchBrite pad and
use the pad to clean and roughen the areas
where the mating dual-locks will be applied to
the frame. Wipe off and allow to dry.
3. Remove the mating dual-lock strips from the
back of the panel and apply to the correct
locations on the frame. See Figure 3-22.
3.15 Upper Facing Panels, Steel
Dual-Lock
Fasteners
MAX/Wall
Technical Wall System
®
or Fabric
Tools Required:
None
Upper Panel
Upper
Panel
Intermediate
Cross Channel
Figure 3-23 Upper Facing Panels
Procedure:
1. Place the top of the upper panel into the opening
of the top frame rail.
2. Lift the panel upward and rotate the bottom of
the panel toward the intermediate cross rail until
the flanges abut.
3. Allow the panel to slide downward tho engage
the angled locking flange onto the intermediate
rail. See Figure 3-23.
Top Frame Rail
Intermediate
Cross Channel
31
Advertisement
Table of Contents
