Table of Contents
Advertisement
MAX/Wall
Technical Wall System
®
Section 4 – Installing Supporting Furniture and Casework
4.3
Cantilever Corner Work Surface
o
(90
) to Wall Frame
12. When the cantilevered work surfaces are installed next to
each other at the same height, they must be bolted
together. Insert a 5/16-18 x 3-1/2" HHMS through the
hole at the front of each cantilevered leg and secure with
a 5/16-18 nut.
Note: Washers are provided to shim between
the cantilevered legs if necessary.
13. Attach the top to the corner work surface
frame using the top clamps and No. 10 x
1" screws. Top clamps are hooked onto
"C" channels on cantilevered legs.
Location and number of clamps to be
used is dependent on the number of
holes pre-drilled in the top.
40
(cont.)
Wall Frame
Corner Top
Support
5/16-18 x 3-1/2"
Corner Cantilever
Frame Assembly
Figure 4-8 Attaching Corner Cantilever Frame
Wall Frame
HHCS
5/16-18 Nut
Wall Frame
Cantilever
Frame
Advertisement
Table of Contents
