Transport - Landoll 6230 Series Operator's Manual

4-21 TRANSPORT

4-21.1 Check and follow all federal, state, and
local requirements before transporting the
disc.
4-21.2 The disc should be transported only by
tractor required for field operation. The imple-
ment weight should not exceed more than
1.5 times the tractor weight. Unless noted on
the implement, maximum transport speed is
20 mph for the implement. Slow down when
driving on rough roads. Reduce speed when
turning, or on curves and slopes to avoid tip-
ping.
4-21.3 A safety chain is provided with the im-
plement to insure safe transport.
a. The safety chain should have a tensile
strength equal to or greater than the gross
weight of the implement. The chain is at-
tached to the lower hitch clevis hole with two
flat washers between the clamp plates to as-
sure a tight connection. Always use a 1" di-
ameter Grade 8 bolt for this connection.
b. Attach the safety chain to the tractor
drawbar (See Figure 4-17). Provide only
enough slack in the chain for turning. Do not
use an intermediate chain support as the at-
taching point for the chain on the tractor. Do
not pull the implement by the safety chain.
c. When unhitching from the tractor attach the
hook end of the chain to a free link close to
the hitch clevis for storage. This will keep the
hook off the ground, reducing corrosion and
keep the hook functioning properly.
d. Regularly inspect the safety chain for worn,
stretched, or broken links and ends. Replace
the safety chain if it is damaged or deformed
in any way.
4-20
SAFETY
CHAIN
HITCH WELDMENT
6230hitchadj
Figure 4-17 Hitch and Safety Chain
4-21.4 Check that tires are of proper size, load
rating, and inflated to manufacture specifica-
tions before transporting. Check wheel lug
bolts to insure tightness.
4-21.5 Know the transport heights and widths
of the unit before transporting. Attachments
such as leveling harrows can increase the
transport dimensions of the implement. Use
caution when transporting near bridges and
power lines.
WARNING
ELECTROCUTION CAN OCCUR WITH-
OUT DIRECT CONTACT.