Leveler Assembly - Landoll 6230 Series Operator's Manual

3-2 LEVELER ASSEMBLY

3-2.1 Install a hardened steel wear bushing in
the leveler L link (See Figure 3-2).
3-2.2 Attach the leveler L link to the front
mount of the center frame with a 1-8 x 4-1/2
hex head cap screw and hex lock nut.
3-2.3 With a 1-8 x 4 hex head cap screw and
hex lock nut attach the leveler ball joint link
to the leveler L link.
3-2.4 Connect the bottom end of the leveler
ball joint link to the rear mounting holes of
the hitch using a 1-8 x 4-1/2 hex head cap
screw and hex lock nut.
Note: When the hitch is in the upper mount-
ing position, the leveler ball joint link is
mounted in the lower holes. When the hitch
is in the lower position, the link is mounted in
the top mounting holes. See Section 4-12 for
proper adjustment.
3-2.5 Install plastic wear flange bearings into
both ends of the 15-1/4" leveler links. Insert
the bushings on the flat side of the link.
3-2.6 Insert plastic wear flange beariings into
the round tube end of the 8" leveler links. In-
sert the wear bushing on the tube side of the
link.
3-2.7 Slide one end of the 15-1/4" link over
the leveler screw assembly. Slide the large
end of the 8" link over the other link and se-
cure with a 1" washer and 5/16" x 2-1/2
spring slotted pin. Repeat this for the other
side of the leveler screw assembly.
3-2.8 Attach the bottom end of the 8" leveler
links to center frame mount located in the
middle of the frame using 1" x 7-7/8" leveler
pin, washers, and 5/16" x 2-1/2" spring
slotted pins.
3-2.9 Secure the rear of the 15-1/4" leveler
links to the top holes of the mounting plates
located on the center lift using 1" x 7-7/8"
leveler pin, washers, and 5/16" x 2-1/2"
spring slotted pins.
Note: If using a harrow attachment, see Sec-
tion 4-11 on which mounting hole to use.
3-5