4-17 DEPTH STOP ADJUSTMENT (MANUAL)
The operating depth of the disc is controlled by
a single-point depth stop. The stop is located at
the center front of the machine.
4-17.1
Adjust the depth stop by turning the
handle in (clockwise) to increase operating
depth (See Figure 4-16). Turn the handle
out (counter-clockwise) to decrease operat-
ing depth. One turn will equal approximately
3/16" adjustment in depth.
4-17.2
The gauge on the side of the depth stop
tube gives a reference for depth setting. The
"A" setting refers to maximum operating
depth.
IMPORTANT
FOR MAXIMUM OPERATING DEPTH, THE
LIFT WHEELS MUST BE IN CONTACT WITH
THE GROUND AND CARRY SOME OF THE
MACHINE WEIGHT.
WHEELS OFF THE GROUND, PERMITS UN-
CONTROLLED DEPTH OF EACH FRAME SEC-
TION AND DOES NOT ALLOW THE LEVELER
TO FUNCTION PROPERLY.
RAISING THE LIFT
DEPTH STOP TUBE
DEPTH STOP GAUGE
DEPTH STOP
HANDLE
6230depthstopadj
Figure 4-16 Depth Stop Adjustment (Manual)
4-17