Leveling (Side To Side) - Landoll 6230 Series Operator's Manual

4-8 LEVELING (SIDE TO SIDE)

4-8.1 Leveling the disc side-to-side involves
leveling the wing frame to the center frame.
The unit should be level side-to-side when
operating in the field.
4-8.2 An adjustable radius rod connects the
main lifts together on the center frame and
keeps them operating in unison. The radius
rod should be set at 24" pin centers (See
Figure 4-7). No further adjustment should be
required. Any other adjustment other than
this can severely damage frame and lift com-
ponents.
4-8.3 To level the unit, verify that all tires are
properly inflated, and that the center radius
rod adjustment has been properly set. With
the implement unfolded, raise the unit to fully
extend the lift cylinders. Continue to hold the
tractor lever 30-60 seconds to insure that the
cylinders are
rephasing lift system has been purged of air.
Lower the unit until the disc blades are ap-
proximately 1" off the ground. On the center
frame, measure the distance from the walk-
ing beam spindle to the bottom side of the
frame (See Figure 4-8). Measure the same
distance on the wing frame. The wing frames
are generally set to the same distance or
slightly higher than the center frame. Adjust-
ing the anchor at the base end of each wing
lift cylinder sets wing frame height (See Fig-
ure 4-9).
4-8
fully extended and the
Figure 4-7 Radius Rod Measurement
Figure 4-8 Leveling from Side to Side