Attaching To The Tractor; Transport - Landoll Wing Tilloll 876 Series Operator's Manual

Attaching to the Tractor

1. Align the tractor drawbar with the machine. Raise or
lower the Tilloll ring hitch, as needed, using the
swivel jack. Attach the unit with proper size hitch pin.
2. Clean all hydraulic couplings and attach to the
tractor. When properly attached, the hydraulic control
lever should cause the Tilloll to:
a. Lower to the ground when the control arm is
moved forward or downward, and
b. Raise when the control arm is moved backward
or upward.
3. Fully extend the hydraulic gauge wheel cylinders,
and place the cylinder lockouts in the transport lock
position over the cylinder rods. Secure the lockouts
with the lockout pins (See Figure 4-2.)
4. Always place the swivel jack on the interior mount
before setting the machine in motion.
Figure 4-2: Transport Locks

Transport

1. Raise the unit to full transport height.
2. Fold the wings.
IMPORTANT
When folding or unfolding wings, operate tractor
engine at a fast idle on 30', 35', and 40' units, and
hold hydraulic valve on tractor open to assure
smooth operation.
3. Place the transport lock brackets on the rods of the
lift cylinders on the main frame and pin in place (See
Figure 4-2.)
Failure to use transport lock pins during
transport may result in permanent equipment
damage, serious injury, or death.
IMPORTANT
When transporting farm implements on public roads,
it is the responsibility of the operator to abide by
state and local laws concerning wide load, speeds,
and safety lighting equipment. The slow moving
vehicle sign can be attached to the implement when
necessary.
OPERATION AND MAINTENANCE

WARNING
4-3