Table of Contents
Advertisement
TROUBLESHOOTING GUIDE
The Troubleshooting Guide, shown below, is included to help you quickly locate problems that can hap-
pen using your 6230 Disc. Follow all safety precautions stated in the previous when making any adjust-
ments to your machine.
PROBLEM
UNIT NOT LEVEL, LEAVING CENTER RIDGE
UNIT NOT LEVEL, LEAVING CENTER FURROW
UNIT NOT LEVEL, LEAVING RIDGE ON OUTSIDE
OF UNIT
UNEVEN DEPTH
PROBABLE CAUSE:SOLUTION
Leveler not adjusted properly: adjust leveler, lower
front gang
Hitch adjustment too low: raise implement hitch
point
Gauge wheels carrying too much weight: raise
gauge wheels
Leveler not adjusted properly: adjust leveler, raise
front gang
Hitch adjustment too high: lower implement hitch
point
Unit not level front to rear, front running too
deep: adjust unit to be level.
Wings not level with center frame: adjust side to
side level. Wings should typically be set even with or
slightly higher than center section
Operating speed too fast, front gang moving soil
past rear gang: slow down to proper operating
speed for field conditions.
Hitch adjustment too high: lower implement hitch
point.
Gauge wheels too high, allowing wings to go to
deep: properly reset gauge wheels.
Frame not level side to side: level center frame
side to side.
Wing frames and center frame not level: level
wing frames to center frame
Lift cylinders not in phase: Fully extend lift
cylinders and hold hydraulic lever until all cylinders
are fully extended
Lift wheels not carrying enough weight: adjust
depth stop and raise implement
Fold cylinders not fully extended to allow wings
to flex: extend fold cylinders fully.
Tire pressure too low: check inflation
Unit not level front to rear: adjust unit to be level.
5
5-1
Hide quick links:
Advertisement
Table of Contents
