Landoll 6230 Series Operator's Manual page 61

4-8.4 An adjusting wrench is provided to
make this adjustment. It may be necessary
to lower the wing to the ground and relieve
weight on the cylinder anchor to make this
adjustment. If required, fully raise the imple-
ment, lower to just above the ground, and
re-verify measurements. Repeat as neces-
sary and securely tighten the cylinder anchor
when complete.
BASE END
ADJUSTMENT
WING
FRAME
6230wingliftadj
Figure 4-9 Wing Lift Adjustment
3-3/4 x 10
HYDRAULIC
CYLINDER
WING LIFT
WHEEL ASSEMBLY
4-9