Landoll 6230 Series Operator's Manual page 31

3-7 FOLD CYLINDER MOUNT
3-7.1 For 21'-23' models, assemble the fold
cylinder mount to the rear cross bar where
the center rear gangs meet in the frame (See
Figure 3-7). Attach using 5/8 x 4 x 6-1/2
u-bolts and hex lock nuts.
3-7.2 For 26' models, assemble the fold cylin-
der mount to the middle cross bar of the cen-
ter frame (over the leveler spring assembly)
using 5/8 x 4 x 6-1/2 u-bolts and hex lock
nuts (See Figure 3-7).
3-7.3 For 29' models, assemble two fold cylin-
der mounts to the center frame using 5/8 x 4
x 6-1/2 u-bolts and hex lock nuts (See Fig-
ure 3-7). Place one mount on the middle
cross bar over the leveler spring assembly,
and the other mount over the rear cross bar
where the center rear gang meets.
3-7.4 For 30' models, install the fold cylinder
mount over the middle center frame cross
bar (over the leveler spring assembly) (See
Figure 3-7). Attach using 5/8 x 4 x 6-1/2
u-bolts and hex lock nuts. Position the fold
cylinder mount so that the hose loops point
forward.
3-7.5 For 33'-36' models, assemble two fold
cylinder mounts to the center frame using
5/8 x 4 x 6-1/2 u-bolts and hex lock nuts.
Place one mount on the middle cross bar
over the leveler spring assembly, and the
other mount behind the rear cross bar where
the center rear gangs meet. See Figure 3-7
for proper placement. Position both fold cyl-
inder mounts so that the hose loops point
forward.
3-15