Tractor Preparation; Disc Preparation - Landoll 6230 Series Operator's Manual

4-1 TRACTOR PREPARATION

The Landoll 6230 Disc is designed to be pulled
by tractor equipped with a double lip or clevis type
hitch. If your tractor is not equipped as such, you
need to purchase the hitch from your local tractor
dealer. If your Disc is equipped with the clevis op-
tion, this should be removed. The clevis option is
only for transport use.
Before attaching the Disc, prepare the tractor
as follows:

4-2 DISC PREPARATION

Figure 4-1 Disc Scraper Adjustment to Disc
4-2
Blade
4-1.1 Inflate the rear tractor tires equally and
add ballast according to the tractor opera-
tor's manual.
4-1.2 Lock the tractor drawbar in the center
position.
4-2.1 Prior to operating the 6230 Disc, inspect
it thoroughly for good operating condition.
4-2.2 Replace worn or missing parts.
4-2.3 When the machine is new, check the
bolt tightness after a few hours of operation.
Tighten any loose nuts or bolts. Check the lift
wheel lug bolts daily.
4-2.4 Check the lift wheel tire inflation. Inflate
all tires equally to avoid side draft. Follow the
tire manufacturer's recommended pressures
listed on the sidewall of the tires.
4-2.5 Check disc scrapers for proper adjust-
ment to the disc blade. (See Figure 4-1).
4-2.6
Lubricate the machine as shown in Sec-
tion 4-22 (See Figure 4-19).