Electronic Depth Control Adjustment - Landoll 6230 Series Operator's Manual

4-18 ELECTRONIC DEPTH CONTROL ADJUSTMENT

The optional Electronic depth control is avail-
able to work with John Deere 7720, 7820, 7920
(IVTÔ transmisson only), 8000, and 9000 series
tractors equipped with the TouchSetÔ depth Con-
trol. This allows the operator to set one or more
depth control stops from the tractor. TouchSetÔ
depth control must already be installed on the trac-
tor to be able to use the electronic depth control.
4-18
4-18.1 To be able to use the Electronic Depth
Control, adjust the connecting linkage be-
tween the depth control lever and the depth
stop mounting plate to 5-1/2" length (See
Figure 3-6).
4-18.2 Rotate the manual depth stop handle
clockwise to fully retract the hydraulic depth
stop. This will allow the electronic stop to
function properly without being stopped inad-
vertently.
4-18.3 Connect the electronic depth control
harness to the electrical connector at the
rear of the tractor.
4-18.4 Read and follow the tractor manufac-
turer's operating manual for operating and
setting the depth from within the tractor cab.
4-18.5 **TouchSet, IVT
marks of John Deere.
are registered trade-