4-4.
Rear Panel
4-4-1.
Removal and Installation of Rear Panel Assembly
Preparation
1.
Remove the cover. (Refer to
2.
Remove the plug-in board on the rear side. (Refer to
on the Rear
Side")
Procedure
1.
Disconnect the harness from the connector CN900 on the SDP-17 board.
2.
Disconnect the harness from the connector on the power block assembly.
3.
Remove the two screws, and remove the heat spreader (P) .
4.
Remove the eight screws, and remove the rear panel assembly.
B3 x 5
5.
Install the removed parts by reversing the steps of removal.
4-4-2.
SDP-17 Board
Preparation
1.
Remove the rear panel assembly. (Refer to
Procedure
1.
Remove the four screws, and remove the cover (SDP-17) and the fiber cable cover.
2.
Disconnect the harness from the connector CN200 on the SDP-17 board.
HDCU2500
"4-2-1. Power Block Assembly
"4-5-2. Installing/Removing Plug-in Boards and Blank Panels
Heat spreader (P)
B3 x 5
Connector
(Power block assembly)
CN900
(SDP-17 board)
Rear panel assembly
"4-4-1. Removal and Installation of Rear Panel
(D00)")
Harness
Harness
B3 x 5
B3 x 5
B3 x 5
Assembly")
4-16