Install The Road Switch; Install The Node Harness - Raven SmarTrax Installation Manual

Case ih x010, x120, and x230 series steering ready combines

Hide thumbs Also See for SmarTrax:

Table of Contents

HAPTER

INSTALL THE ROAD SWITCH

FIGURE 7. Road Switch Assembly

1. Select a a suitable location for the road switch assembly (P/N 063-0173-505) to be installed.

NOTE:

The road switch should be mounted in a location within the operator's reach.

2. Remove the backing from the double-sided tape.

3. Install the road switch assembly to the chosen mounting location.

FIGURE 8. Node Harness Installed on SmarTrax Node

1. Install the two large, rectangular connectors of the node harness (P/N 115-4001-181) into the correct ports of

the node, tightening the bolts on the connectors to secure the connections.

2. Locate the ENABLE connector on the node harness and connect it to the foot switch (P/N 063-0172-470) cable

connector.

3. Locate the ROAD SWITCH connector and connect it to the installed road switch (P/N 063-0173-505).

Case IH X010, X120, and X230 Series Steering Ready Combines SmarTrax™ Installation Manual

Table of Contents