Raven SmarTrax Installation Manual page 19

FIGURE 18. Machine's Steering Valve
3. Route the 6-pin Deutsch connector from the valve harness under the cab and toward the steering valve.
4. Trace the existing cables coming out of the steering valve.
5. Disconnect the 6-pin connectors located directly behind the steering valve.
FIGURE 19. Steering Valve Connection
6. Connect the 6-pin connector from the valve harness to the mating 6-pin steering valve connector.
FIGURE 20. Machine's Wheel Angle Sensor Connection at Rear Axle
7. Locate the wheel angle sensor (WAS) cable on the left steering cylinder at the machine's rear axle.
P/N 016-5032-024 Rev. C
CAB COMPONENT INSTALLATION
15