FIGURE 9. Machine's Steering Column
Rubber
Shroud
4. Route the SPROCKET connectors to the steering column in the front of the cab.
FIGURE 10. Gear Tooth Sensor and Connections
Gear Tooth
Sensor
5. Pull down the rubber shroud at the base of the steering column to expose the gear tooth sensor and its
connectors.
6. Disconnect the machine's gear tooth sensor connections.
FIGURE 11. Node Harness Connected to Gear Tooth Sensor
P/N 016-5032-024 Rev. C
CAB COMPONENT INSTALLATION
Steering
Column Cover
Gear Tooth
Sensor
Connections
11