Install The Valve Harness - Raven SmarTrax Installation Manual

2. Using the holes in the foot switch as a template, drill holes in the floor of the cab.
3. Secure the foot switch to the floor by installing the supplied screws in each of the mounting holes.
4. Locate the ENABLE connector on the node harness (P/N 115-4001-191) and connect it to the foot switch cable
connector.

INSTALL THE VALVE HARNESS

FIGURE 21. Valve Cable Routed Through Access Point
1. Route the valve cable into the cab from the foam access point under the convenience tray on the right side of
the seat.
FIGURE 22. Valve Harness Connected to Node Harness
2. Connect the rectangular 12-pin connector on the valve cable (P/N 115-4001-111) into the mating connection on
the node harness (P/N 115-4001-191).
P/N 016-5032-043 Rev. A
Cab Component Installation:
29