Raven SmarTrax Installation Manual page 27

FIGURE 8. Convenience Tray Removed
13. Remove the convenience tray from the right-rear corner of the cab.
14. Locate the POWER GND PORT on the machine's harness in the convenience tray compartment.
15. Connect the machine's POWER GND PORT connector to the mating 6-pin POWER connector on the node
harness.
16. Connect the node cable's CAN connector to the CAN Adapter Cable (P/N 115-4001-248).
17. Locate and disconnect the machine's green 12-Pin AUTOGUIDANCE INTERFACE connections from under the
instructional seat.
18. Install the CAN adapter cable between the green connectors.
FIGURE 9. DGPS OUT Connected to Console Receiver Connection
Console
Cable
19. Connect the DGPS connector on the node harness to the GPS receiver.
20.Route the DGPS OUT connector on the node harness to the A-post at the front-right corner of the cab.
21. Connect the DGPS OUT connector to the Viper Pro or Envizio Pro receiver connection.
P/N 016-5032-043 Rev. A
Cab Component Installation:
Console
Receiver
Connection
DGPS Out
(Node Cable
Connection)
23