Install The Left And Right Steering Hoses - Raven SmarTrax Installation Manual

C 3
HAPTER

INSTALL THE LEFT AND RIGHT STEERING HOSES

1. Locate and disconnect the machine's left steering hose from the left steering cylinder.
NOTE: The left steering hose is connected to the fitting located closest to the center of the machine.
2. Route and connect the left steering hose to the Port A2 of the installed flow switch (P/N 334-0003-085).
FIGURE 7. Installed Left Steering Hose
3. Install a -6 ORFS M/M/F swivel run tee adapter fitting (P/N 333-0012-069) on the open steering cylinder port.
4. Install the straight end of the supplied hydraulic hose (P/N 214-1000-318) on the opposite end of the installed
tee fitting.
5. Connect the 90° end of the installed hydraulic hose to the fitting installed in Port B3 of the installed flow switch.
6. Install the 90° end of the supplied hydraulic hose (P/N 214-1000-318) on the 90° end of the installed tee fitting.
7. Connect the straight end of the installed hydraulic hose to Port A of the SmarTrax valve.
FIGURE 8. Installed Right Steering Hose
8. Locate and disconnect the machine's right steering hose from the right steering cylinder.
9. Install a -6 ORFS M/M/F swivel run tee adapter fitting (P/N 333-0012-069) in the open steering cylinder port.
10. Connect the machine's right steering hose to the opposite end of the installed tee fitting.
11. Install the 90° end of the supplied hydraulic hose (P/N 214-1000-659) on the 90° end of the installed tee fitting.
12. Connect the straight end of the installed hydraulic hose to Port B of the SmarTrax valve (P/N 334-0003-088).
16 Case IH Patriot 4440, Non-Steer Ready MY 17 and Newer SmarTrax Installation Manual
Right
Steering
Hose
Left
Steering
Hose