Install The Valve Harness - Raven SmarTrax Installation Manual

Chapter 5
Power Connections
FIGURE 4.
Ground
Stud
Connect the ring terminal power and ground connections to the power rail.
4.
Route the two ring terminals through the access hole in the right-rear corner of the cab to access
a.
panel.
Remove the access panel cover on the right side of the cab to access the power rail.
b.
Connect the red ring terminal to any of the four power studs under the plastic cover.
c.
Connect the white ring terminal to the common ground stud.
d.
Connect the DGPS IN connector to the receiver or other GPS source.
5.
Connect the DGPS OUT connector to the DGPS connector on the Raven console cable.
6.
Connect the 12-pin connector of the WAS adapter harness to the mating connector on the valve harness (P/
7.
N 115-4001-080).
Locate and disconnect the terminator from the machine's existing CAN system.
8.
Connect the 4-pin connector on the node harness to the open CAN connection.
9.
Install the terminator on the remaining 4-pin connection on the node harness.
10.

Install the Valve Harness

Route the valve harness cable outside and under the cab to the SmarTrax valve (P/N 063-0131-129).
1.
Connect the PSI connector to the pressure transducer (P/N 422-0000-086) installed in Port PS of the
2.
SmarTrax valve.
22 Versatile SX275 SmarTrax™ Installation Manual
Power
Rail