Install The Foot Switch; Install The Node Harness - Raven SmarTrax Installation Manual

Install the Foot Switch

Foot Switch Installed
FIGURE 3.
Select a suitable location for the foot switch (P/N 063-0172-470) to be installed.
1.
Note:
The foot switch should be installed in a location where the operator has easy access to it and is
able to fully press the pedal.
Using the holes in the foot switch as a template, drill holes in the floor of the cab.
2.
Secure the foot switch to the floor by installing the supplied screws in each of the mounting holes.
3.

Install the Node Harness

Connect the 12-pin connector of the WAS harness (P/N 115-4001-220) to the mating 12-pin connector of
1.
the node harness (P/N 115-4001-078).
Install the two large, rectangular connectors of the node harness (P/N 115-4001-078) into the correct ports
1.
of the node, tightening the bolts on the connectors to secure the connections.
Locate the ENABLE connector on the node harness and connect it to the foot switch cable connector.
2.
Connect the LOGIC POWER connector to the AUX POWER OUTPUT connector on the console cable.
3.
P/N 016-4001-100 Rev. C
Cab Component Installation
21