1. Manuals
  2. Brands
  3. Xilinx Manuals
  4. Microcontrollers
  5. Virtex-7 FPGA VC7222 IBERT
  6. Getting started manual

Attach The Gtx Quad Connector - Xilinx Virtex-7 FPGA VC7203 Characterization Kit IBERT Getting Started Manual

Hide thumbs Also See for Virtex-7 FPGA VC7203 Characterization Kit IBERT:
Table of Contents

Advertisement

Chapter 1: VC7203 IBERT Getting Started Guide

Attach the GTX Quad Connector

Before connecting the BullsEye cable assembly to the board, firmly secure the blue
elastomer seal provided with the cable assembly to the bottom of the connector housing if
it is not already inserted (see
Note:
X-Ref Target - Figure 1-4
Attach the Samtec BullsEye connector to GTX Quad 115
indexing pins on the bottom of the connector with the guide holes on the board. Hold the
connector flush with the board and fasten it by tightening the two captive screws.
X-Ref Target - Figure 1-5
10
Send Feedback
Figure
Figure 1-4
is for reference only and might not reflect the current version of the connector.
Figure 1-4: BullsEye Connector with Elastomer Seal
Figure 1-5: BullsEye Connector Attached to Quad 115
www.xilinx.com
1-4).
(Figure
VC7203 IBERT Getting Started Guide
UG847 (v4.0) November 6, 2013
1-5), aligning the two

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Virtex-7 FPGA VC7203 Characterization Kit IBERT and is the answer not in the manual?

Questions and answers

Related Manuals for Xilinx Virtex-7 FPGA VC7203 Characterization Kit IBERT

Related Products for Xilinx Virtex-7 FPGA VC7203 Characterization Kit IBERT

Table of Contents