Aastra 480i Administrator's Manual page 40

.
Aastra Web UI
1. Click on Advanced
Settings->Network->Type of
Service,DSCP.
2. Choose a Protocol (SIP, RTP,
and/or RTCP), and enter a value
from 0 to 63.
Note: If you change the ToS/DSCP set-
ting for a Protocol, and VLAN is
enabled, you will need to map
the applicable priority to the Pro-
tocol setting as shown in the
table "DSCP Range/VLAN Prior-
ity" on page 31
mation, see the section
"Configuring VLAN (optional)"
on page 32.
3. Click
changes.
4. Click on Operation->Reset.
5. In the "Restart Phone" field
click to restart the IP
phone.
32 IP Phone SIP Admin Guide
For more infor-
to save your
Configuring VLAN (optional)
Use the following procedures to
configure VLAN on the IP phone.
Note: VLAN is disabled by default.
When you enable VLAN, the IP
phones use the default settings
for each VLAN parameter. You
can change the default settings if
required using the following pro-
cedures..
Configuration files
For specific parameters you can set
in the configuration files, see
"Virtual Local Area Network
(VLAN) Settings"
IP Phone UI
1. Press won the phone to
enter the Options List.
2. Select Network.
3. Select VLAN.
To globally enable/disable VLAN
and set priority for non-IP packets:
4. Select VLAN Enable, and press
Change to set VLAN Enable to
Yes (or No to disable)
5. Press Done to save the change.
6. Select Phone.
7. Select Priority.
8. Select Other and enter a non-IP
priority value from 0 to 7 for
non-IP packets.
9. Press Done to save the change.
10.Press Done again to return to
the VLAN Phone menu.
To set VLAN ID and priority for
Port 0:
11.Select VLAN ID and enter a
value from 1 to 4094 to specify
the VLAN ID of Port 0.
on page 122.