Aastra 480i Administrator's Manual page 33

TFTP
- Select TFTP.
- Select Primary.
- Select Primary TFTP.
- Enter the IP address or qualified
domain name of the primary TFTP
server
- Press Done to save the change.
Optional: You can also configure
an alternate TFTP server if
required. If Alternate TFTP is
enabled, you must also enter an IP
address or qualified domain name
for the alternate TFTP server.
FTP
- Select FTP Server.
- Enter the IP address of the FTP
server.
- Press Done.
Optional: You can enter a
username and password for
accessing the FTP server if
required:
- Select FTP Username.
- Enter a username for accessing the
FTP server.
- Press Done.
- Select FTP Password.
- Enter a password for accessing the
FTP server.
- Press Done.
HTTP
- Select HTTP Server.
- Enter the IP address of the HTTP
server.
- Press Done.
- Select HTTP Path.
- Enter the HTTP sub-directory path
name. If the IP phone's files are
located in a sub-directory beneath
the server's HTTP root directory,
the relative path to that sub-
directory should be entered in this
field.
- Press Done.
7. Press Done to finish configuring
the configuration server proto-
col for the IP phone.
Note: The session prompts you to
restart the IP phone to apply the
configuration settings.
8. Select Restart.
Aastra Web UI
1. Click on Advanced
Settings->Configuration Server.
2. Select the protocol from the
"Download Protocol" list box.
The IP phone uses the protocol
you select to download new
firmware and configuration files
from the configuration server.
Use the following table to con-
figure the applicable server.
TFTP
- Enter an IP address or qualified
domain name in the "TFTP Server"
field.
You can also configure
Optional:
an
alternate TFTP server if required.
If "Use Alternate TFTP" is
enabled, you must also enter an IP
address or qualified domain name
for the alternate server in the
"Alternate TFTP" field.
FTP
- Enter an IP address in the "FTP
Server" field.
ou can enter a user-
Optional: Y
name and password for accessing
the FTP server if required.
- Enter a user name for a user that will
access the FTP server in the
"FTP User Name" field.
- Enter a password for a user that
allows access to the FTP server in the
"FTP Password" field.
HTTP
- Enter an IP address in the "HTTP
Server" field.
- Enter a root sub-directory path for
the HTTP server in the "HTTP Path"
field.
Optional: You can enter a list of
users to be authenticated when they
access the HTTP server in the "HTTP
POST Authentication List" field.
3. Click
changes.
Note: The session prompts you to
restart the IP phone to apply the
configuration settings.
4. Select Operation->Reset and
click .
IP Phone SIP Admin Guide
to save your
25