Update Caller Id During A Call; Boot Sequence Recovery Mode - Aastra 480i Administrator's Manual

Update Caller ID During a Call

It is possible for a proxy or call
server to update the Caller ID
information that displays on the
phone during a call, by modifying
the SIP Contact header in the 200
OK message and/or in a re-INVITE
message. The phone displays the
updated name and number
information contained within the
Contact header.
The following parameter allows
the system administrator to enable
or disable this feature:
• sip update callerid
This parameter is configurable via
the configuration files only.
Configuration files
For the specific parameter you can
set in the configuration files for
enabling/disabling the update of
caller ID during a call, see
Caller ID Setting."

Boot Sequence Recovery Mode

You can force the IP phone into
recovery mode by pressing the 1
and # keys during boot up when
the logo displays. This feature is
enabled by default on the IP
phone.
You can disable this feature using
the following parameter in the
configuration files:
• force web recovery mode
disabled
Valid values for this parameter are
0 (false) and 1 (true). Default is 0
(false).
104 IP Phone SIP Admin Guide
"Update
on page 179.
A boot counter increments after
each faulty boot. When the counter
reaches a predetermined value, it
forces Web recovery mode. The
counter is reset to zero upon a
successful boot.
The predetermined value is set
using the following parameter in
the configuration files:
• max boot count
A zero (0) value disables this
feature. The default value is 10.
You can configure the boot
sequence recovery mode
parameters using the configuration
files only.
Configuring Boot Sequence
Recovery Mode
You configure the boot sequence
recover mode using the
configuration files.
Configuration files
For the specific parameters you can
set in the configuration files for
boot sequence recovery mode, see
"Boot Sequence Recovery Mode."
on page 180.