Mounting The Sae J1772 Connector Holster - ClipperCreek HCS User Manual

HCS User Manual
MOUNTING THE SAE J1772 CONNECTOR
HOLSTER
The SAE J1772 connector holster is included to provide a
convenient protective housing for the SAE J1772 connector head
when it is not in use.
• The SAE J1772 connector holster should be placed so that
users have easy and safe access to the SAE J1772 connector.
•
• For indoor installation, mount the SAE J1772 connector holster
between 18" (45.7 cm) and 48" (122 cm) above the ground or
grade.
•
• For outdoor installation, mount the SAE J1772 connector
holster between 24" (61 cm) and 48" (122 cm) above the
ground or grade.
• The SAE J1772 connector holster has two vertically aligned
mounting holes spaced 5.45" (13.8 cm) apart, one each on the
enclosure top and bottom. Use a ruler or template to mark hole
locations on the mounting surface.
• The vertical alignment of the HCS and SAE J1772 connector
holster mounting holes allows for the convenient mounting
of both components onto the same post or wall structure. For
example, the holster may be mounted directly above the HCS.
• Place the SAE J1772 connector holster such that both mounting
holes can take advantage of solid structural framing inside of
the wall or a strong wall surface such as plywood.
• A set of exterior wood screws and stainless steel washers
are included for the purposes of mounting the SAE J1772
connector holster to a wooden surface.
• For mounting to a solid surface such as concrete, brick, or
stone, alternate hardware may need to be procured. Examples
of solid-wall mounting hardware include multi-sets, wedge
anchors and sleeve anchors. Use the type of mounting
hardware most appropriate for the supporting structure.
28