Mounting Procedures - ClipperCreek HCS User Manual

MOUNTING PROCEDURES

Determine the wall mounting position of the EVSE:
• On the hardwired HCS, the three service conductors are
shielded by 3' (1 m) of flexible conduit at the bottom of the
unit. The HCS must be positioned such that this conduit can
reach a nearby junction box.
• On the plug-in HCS, the NEMA plug head is connected by
12" (30.5 cm) of cable (including the plug head) to the bottom
side of the HCS. The plug-in HCS must be positioned such
that this plug can safely be inserted into a wall-mounted
NEMA socket.
• Position the bottom of the EVSE at a comfortable height and
at least 18" (45.7 cm) above the ground for indoor
installations and 24" (61 cm) off the ground for outdoor
installations. Ensure that the LEDs on the front panel of the
EVSE can clearly be seen by the user of the device.
• The HCS has two vertically aligned mounting holes spaced
17" (43.2 cm) apart, one each on the enclosure top and
bottom. Use a ruler or template to mark hole locations on the
mounting surface.
WARNING: For safety, always turn off input power to the
EVSE at the circuit breaker panel prior to plugging it in or
wiring it to the service lines. Likewise, turn off the circuit
breaker prior to unplugging it or disconnecting the unit from
the service lines.
AVERTISSEMENT: Pour sécurité, toujours désactiver le
courant d'entrée de la station de recharge au niveau du
disjoncteur du panneau avant de le brancher ou de câblage
à les lignes de service. De même, coupez le disjoncteur
avant de le débrancher ou déconnecter l'unité à partir des
lignes de services.
ADVERTENCIA: Por razones de seguridad, siempre apague
la alimentación de entrada a la estación de carga en el panel
de interruptores automáticos de circuito antes de enchufarlo
o cablearlo a las líneas de servicio. Igualmente, apague el
interruptor automático de circuito antes de desenchufarlo o
desconectar la unidad de las líneas de servicio.
25
HCS User Manual