Mounting The Connector Holster - ClipperCreek LCS Series User Manual

MOUNTING THE SAE-J1772™
CONNECTOR HOLSTER
The SAE-J1772™ connector holster comes standard to provide a convenient,
protective housing for the SAE-J1772™ connector head when it is not in use.
• The SAE-J1772™ connector holster should be placed so that users have
easy and safe access to the SAE-J1772™ connector.
• For indoor installation, mount the SAE-J1772™ connector holster between
18 and 48 inches above the ground or grade.
• For outdoor installation, mount the SAE-J1772™ connector holster between
24 and 48 inches above the ground or grade.
• The SAE-J1772™ connector holster has two vertically aligned mounting
holes spaced 5.45" apart, one each on the enclosure top and bottom. Use a
ruler or template to mark hole locations on the mounting surface.
• The vertical alignment of the LCS and SAE-J1772™ connector holster
mounting holes allows for the convenient mounting of both components
onto the same post or wall structure. For example, the holster may be
mounted directly above the LCS.
• Place the SAE-J1772™ connector holster such that both mounting holes can
take advantage of solid structural framing inside of the wall or a strong wall
surface such as plywood.
• A set of exterior wood screws and stainless steel washers are included for
the purposes of mounting the SAE-J1772™ connector holster to a wooden
surface.
• For mounting to a solid surface such as concrete, brick, or stone, alternate
hardware may need to be procured. Examples of solid-wall mounting
hardware include multi-sets, wedge anchors and sleeve anchors. Use the
type of mounting hardware most appropriate for the supporting structure.
Figure 6 - Mounting the holster using the exterior wood screws and washers
Page 16
LCS User's Manual