Installation - ATEN RCM101D User Manual

Installation

To install the RCM101D, refer to the installation diagrams on the following
pages (the numbers correspond to the numbers of the steps), and do the
following:
1. Plug your USB keyboard, mouse, DVI monitor, speakers and microphone
into the local console port section located on the RCM101D unit's rear
panel.
2. Use the KVM cable provided with the package to connect the RCM101D's
PC/KVM Port to the keyboard, video, mouse, speakers and microphone
ports of the server or KVM switch that you are installing.
3. (Optional) If you want to use the virtual media function, use the USB 2.0
cable provided with the package to connect a USB port on the server to the
RCM101D's Virtual Media port.
4. (Optional) If you want to use a Laptop USB Console, connect the laptop's
USB to this port.
Note: Check that the Select Switch for the Virtual Media/Laptop USB
Console ports is in the right position.
5. Plug a network cable into the RCM101D's LAN port 1
6. (Optional) Plug a second network cable into the RCM101D's LAN port 2.
Note: Dual LAN operation is optional.
7. (Optional) If you are using a PON device (PN108), connect it to the PON
port with RJ45-to-serial adapters (SA0142).
Note: Serial adapters require a separate purchase.
8. (Optional) If you are using other serial devices, such as a standard modem,
connect it to the Serial port with RJ45-to-serial adapters (SA0142)
Note: Serial adapters require a separate purchase.
9. Plug the power adapter provided with this package into an AC power
source, then plug the power adapter cable into one of the RCM101D's
power jacks.
Chapter 2. Hardware Setup
15