Protocol; Network Adapter; Set Ip; About - ATEN RCM101D User Manual

Protocol

Use this drop-down box to select the type of protocol IPv4 or IPv6, you are
using for the network adapters on your LAN.

Network Adapter

The Network Adapter selection box, located just below the Device List,
pertains to computers that have more than one network adapter installed. Users
can use this to select the adapter that they want Enumerate to be directed to.

Set IP

There are two methods of specifying an IP address: Dynamic, and Static:
 If you want to obtain an IP address dynamically, select Obtain an IP
address automatically (DHCP).
 If you want to use a static IP address, select
the information for:
 IPv4: IP Address, Subnet Mask, and Gateway.
 IPv6: IPv6 Address, Subnet Prefix Length, and Default Gateway
After you have made your changes, click Set IP to set the IP address for the
device you have selected.
Note: The screen will freeze for a moment or two until the utility has finished
setting the IP.

About

Clicking the About button brings up a dialog box with information about the
product – including the current firmware version.

Browser

1. Set your client computer's IP address to 192.168.0.XXX
Where XXX represents any number or numbers except 60. (192.168.0.60 is
the default address of the RCM101D.)
2. Specify the switch's default IP address (192.168.0.60) in your browser, and
you will be able to connect.
3. Assign a fixed IP address for the RCM101D that is suitable for the
network segment that it resides on.
4. After you log out, reset your client computer's IP address to its original
value.
Specify an IP address, then fill in
Appendix
115