Hardware Setup; Stacking And Rack Mounting; Stacking - ATEN RCM101D User Manual

1. Important safety information regarding the placement of this
device is provided on page 107. Please review it before
proceeding.
2. Make sure that the power to any device that you connect to the
installation has been turned off. You must unplug the power
cords of any computers that have the Keyboard Power On
function.
3. Any installation that does not follow the instructions in this
guide may be hazardous.
4. The power source for this product is intended to be supplied by a
power adapter only, not a DC mains.

Stacking and Rack Mounting

Stacking

The RCM101D can be placed on any appropriate level surface that can safely
support its weight plus the weight of its attached cables. To place or stack the
RCM101D, remove the backing material from the bottom of the rubber feet
that came with this package, and stick them onto the switch's bottom panel at
the corners, as shown in the diagram below
Note: To ensure adequate ventilation, allow at least 5.1 cm on each side, and
12.7cm at the back for power cord and cable clearance.

Hardware Setup

Chapter 2
13