Table of Contents
Advertisement
Orion
Revision 3.1
21 May 2020
Orion Carriage Timers Screen
Figure 3 - 24
The Orion Carriage
Timers Screen
Table 3-20. The Orion Carriage Timers Screen Button Descriptions
STATE 1
AUTOHEIGHT DELAY
TENSION ENGAGE
DELAY
FILM FAULT DELAY
This is the Timers Screen. This screen allows adjustment of the timers involved in the
machine cycle. See the Table below for descriptions and parameters of each setting.
Press the numeric display to modify the Autoheight Delay value, in terms of milli-
seconds. This value determines the amount of time that the Carriage will continue to
travel up during the wrap cycle after the Autoheight photoeye no longer detects a
load. This is used to adjust the amount of overlap on the top of the load. Min - 0 ms
Max - 10000 ms
Press the numeric display to set the tension engage delay. This is the amount of
time, in milliseconds, that the tension waits after the start of the cycle to engage the
tension on the film multistretch. This is done to prevent pulling the film tail off of
the load upon starting up. Min - 0 ms Max - 10000 ms
Press the numeric display to modify the Film Fault Delay value, in terms of milli-
seconds. This value determines the amount of time, during a wrap cycle, that the
Multistretch must be inactive before triggering an End of Film Roll or Broken Film
fault. Min - 0 ms Max - 10000 ms
Sentry HP/ LP Flex Stretchwrapper
DESCRIPTION
Machine Manual
System Operation
Page 3-29
Advertisement
Table of Contents
