Table of Contents
Advertisement
Machine Manual
Sentry HP/ LP Flex Stretchwrapper
System Operation
Main Drive Screen
Figure 3 - 21
The Main Drive
Screen
STATE 1
END OF CYCLE
POSITION
SLOWDOWN POSITION
HIGH SPEED
LOW SPEED
Page 3-26
This is the Main Drive screen. This screen allows adjustment of the Main Drive (turnta-
ble.)
Table 3-17. The Main Drive Screen Button Descriptions
Press this button to modify the End of Cycle Position value. This value determines
the tooth count position at which the Main Drive will stop at the end of a wrap
cycle, or when the Home Machine button is pressed. Min - 0 Max - 50
The slow down position is when the turntable starts to decel before stopping at
home. An earlier slow down position might be needed for heavier loads and a later
slowdown position for lighter loads. The value is the tooth count in which the
machine will start to decelerate.
Press this button to send the machine to its Home Position. When pressed, the Car-
riage will travel to its bottom limit, and the Main Drive will travel to its predefined
End of Cycle Position.
Press this button to modify the High Speed value, in terms of percentage. This value
determines the speed at which the Main Drive will travel during the wrap cycle
when High Speed is selected. Min - 1% Max - 100%.
Press this button to modify the Low Speed value, in terms of percentage. This value
determines the speed at which the Main Drive will travel during the wrap cycle
when Low Speed is selected. Min - 1% Max - 100%.
DESCRIPTION
Orion
Revision 3.1
21 May 2020
Advertisement
Table of Contents
