Table of Contents
Advertisement
Orion
Revision 3.1
21 May 2020
Table 3-2. The Run Screen Button Descriptions (Continued)
STATE 1
DESCRIPTION
Press this button to resume the wrap cycle, if the cycle is currently paused.
Press this button to either stop the current wrap cycle or reset any displayed faults.
Press this button to apply the predefined reinforce-
ment wraps to the load. If the Reinforcement Wraps
value is set to zero, reinforcement wraps will be
applied as long as the Reinforce button is pressed.
Press this button to toggle between High Speed and Low Speed operation. When
High Speed is selected, the Main Drive will travel at the predefined High Speed
value during the wrap cycle. When Low Speed is selected, the Main Drive will
travel at the predefined Low Speed value during the wrap cycle.
Press this button to send the machine to its Home Position. When pressed, the Car-
riage will travel to its bottom limit, and the Main Drive will travel to its predefined
End of Cycle Position.
Machine Manual
Sentry HP/ LP Flex Stretchwrapper
System Operation
STATE 2
REINFORCING
Page 3-7
Advertisement
Table of Contents
